Course Content
Review Design
It's always best to start with a plan. Here's what to look for before starting installation.
0/4
Switches and Sensors
00:00
Dimming and “Resume Level”
00:00
3-Way and Multi-Way Switches
00:00
Operating Switches and Lights Quiz
00:05:00
Prewire
Prewire involves routing and pulling wires from the panels to the lights, switches, and devices, as well as wiring from main AC or DC power sources to the panels.
0/4
Lighting Control Panel
00:00
Wiring to Lights
00:00
Wiring to Switches
00:00
Advanced Wiring (USB-C outlets, High Power Strips, Large Chandeliers)
00:00
Trim and Basic Commission
Trim Phase includes connecting lights and switches, grouping lights into zones, pairing switches to lighting zones, configuring occupancy sensors, and assigning keypad/touchpad button actions. Cleaning and trimming the panels. This is usually the last step required for final inspections.
0/2
Wiring AC style Fixtures to Generic Smart Interface Blocks (SIBs)
00:00
Wiring LEDs (Single color and Tunable White) to Generic CCT Smart Interface Blocks (SIBs)
00:00
Accessing via Wifi and Basic Controls
Accessing via Wifi, naming devices and zones, connecting to home wifi, controlling lights, testing switches and sensors.
Installing ReNetA

ReNetA light switches are not like AC switches where you need to purchase 3-way, 4-way, “Dimmer and Follower”, switches just to have more than two switches control a zone of lights.  All LumenCache switches are the same!

When more than one switch is configured to control a single zone, the operation is the same as if it was a single switch zone: Top button turns the lights On and the Bottom turns them Off.  No more out of sync toggles where two are up and one is down and the light is on, and no more running out of the special switch type you need to finish a job.

ReNetA Switches can be wired to the nearest light.  The light and switch don’t even need to be from the same zone.

See more in the Wiring Design chapter.

Previous
Next
0% Complete